Workstation for Novell NetWare Client 32 for DOS/Windows 3.1X

   Introduction:
   -------------
   This document describes the procedure to setup the NetWare Client 32 for
   DOS/Windows 3.1X ODI driver for AcerLAN ALN-201 PCI Ethernet adapter.

   Location of Driver:     \NWSERVER\ALN201.LAN
                           \NWSERVER\ALN201.LDI

   Sample Configuration Files:
   ---------------------------
      STARTNET.BAT:

        SET NWLANGUAGE=ENGLISH
        C:\NOVELL\CLIENT32\NIOS.EXE
        LOAD C:\NOVELL\CLIENT32\LSLC32.NLM
        LOAD C:\NOVELL\CLIENT32\CMSM.NLM
        LOAD C:\NOVELL\CLIENT32\ETHERTSM.NLM
        LOAD C:\NOVELL\CLIENT32\ALN201.LAN SLOT=2 FRAME=Ethernet_802.2
        LOAD C:\NOVELL\CLIENT32\ALN201.LAN SLOT=2 FRAME=Ethernet_802.3
        LOAD C:\NOVELL\CLIENT32\ALN201.LAN SLOT=2 FRAME=Ethernet_II
        LOAD C:\NOVELL\CLIENT32\ALN201.LAN SLOT=2 FRAME=Ethernet_SNAP
        LOAD C:\NOVELL\CLIENT32\IPX.NLM
        LOAD C:\NOVELL\CLIENT32\CLIENT32.NLM


   Simple setup Procedures for NetWare Client 32 for DOS/Windows 3.1X :
   -----------------------------------------------
      Before you start with the installation process, make sure that
      the adapter is properly installed. Make sure that your
      NetWare Client 32 for DOS/Windows 3.1X operating system is properly
      installed.

      1. Copy ALN201.LAN and ALN201.LDI from the AcerLAN Driver Diskette
         subdirectory A:\NWSERVER to your \NOVELL\CLIENT32 subdirectory.

      2. Modify a batch file the commands listed above under
         STARTNET.BAT

      3. Run the batch file.


   Setup Procedures for NetWare Client 32 for DOS/Windows 3.1X :
   -------------------------------------------------------------
      The installation utility INSTALL.EXE is located on Novell's
      "Netware Client 32 for DOS/Windows 3.1X" disk 1. Run INSTALL
      from the DOS prompt.

      The NetWare Client 32 Install program screen will appear. You must
      complete each of the questions.  These options are specific to your
      needs.

      1. In 32-bit Network Board Drivers dialog box, select OTHER DRIVERS
         option.

      2. Insert AcerLAN ALN-201 Driver Diskette into A: and type
         A:\NWSERVER.

      3. Select AcerLAN ALN-201 PCI Ethernet Driver option and finish
         NetWare Client 32 for DOS/Windows 3.1X installation procedure.